i have 2015 hyundai tucson se i had a friend remove my stock stereo and he put in a aftermarket but due to summer and him not using connector crimps the tape had loosen up wen i removed stereo i seen that the wires were cut since we didnt have pinout adapters and were cut to short on both pinout car harness originals so i bout new ones on line and also pinout connectors adapters MY QUESTION IS DO THE ORIGINAL WIRES FROM CAR ORIGINAL PINOUT PLUG wires MATCH THE SAME EXACT KEY WIRES SPOTS AS the after market wires if not can u help me with a color code chart for oem wire harness i have chart for after market harnesses thanks
There's no such connection that I'm aware of VGA 15 pin, you probably mean the Serial COM or rather RS-232, which is totally different. Indeed they look the same but they carry very different data & hence interfacing them is very difficult or useless.
If you share what you are trying to do; we might be able to help you.
Hi, I own an Asus UX31A with a proprietary 12+6 pin NGFF SSD. My disk controller is broken and the laptop boots from time to time and operates for some minutes then hangs and system no longer recognizes the SSD. Boots to the BIOS. I remove the SSD and re-attach. It boots again to Windows, works for some minutes then the same happens.
SSD works with a sata adapter. so I'm pretty sure problem is the controller. PC also boots from a USB disk and runs perfectly.
I wish to connect the SSD to the USB ports (by doing some soldering) from inside the ultrabook's case and run the system from the ssd as an external usb drive.
I can connect the disk with a USB adapter directly to the port, but it is risky as the usb jack can disconnect with a little motion and system will immediately crash.
Can anyone help ? Can I do such a connection by directly soldering some wires?
hi, anybody had any luck to convert hp server 6 pin fans to PWM low noise 4 pin fans. I have this old hp 4500 g2 servers, with 8 redundant fans, that is laud as a fighter plane, it should work with only 4 fans with less load, I try out 4 fan setup, but it stops and powers down.
I have read, that I can short out the blue wire whit 100 ohms and to 0. but do I need to do it with all six-pin connectors on the motherboard ?? ore how?
my goal is to water cool the 2 CPU's and connect six low noise fans to the motherboard, in a new case. but I do not have any luck yet
Anyone recognize this connector? I see there are companies calling it a slim din connector. It seems to be M5 size connector (similar to the M8/M12) style. I see 4 pin versions that are similar but the Key is inverse or reversed. This one was for a video cable.